NOTE: Use paper that meets the specifications of the printer. Paper Roll Specifications
Caution: There is a printer head (a) inside the printer that becomes hot during printing or right after printing. Do not touch the printer head when opening or closing the printer cover.
1. Turn power on
Set the paper with the power on to automatically feed or cue paper.
2. Pull out printer
Push the front face of the printer to unlock (1) and pull out the printer (2).
Caution: Pull out the printer fully. It may damage mPOP.
3. Open printer cover
Pull the cover opening lever forward
to open the printer cover
.
4. Paper setup
Set the paper roll in the direction as shown in the illustration.
5. Close printer cover
Pull the end of the paper straight out (1), sandwich the paper and close the printer cover (2). The setting is completed when the paper is cut automatically.
Note: Remove the cut paper. It may cause a paper jam.
6. Return the printer to its original position
Push the printer until it locks with a clicking sound.
Confirm that the LED display is in standby.
Paper Roll Specifications
Use paper roll that complies to the following specifications.
Paper width (W1) | 57.5±0.5 (mm) |
Maximum roll diameter (D) | φ50 (mm) |
Curling dimension (W2) | 58.0＋0.5,－1 (mm) |
Paper thickness | 53~75 (μｍ) |
Axial | Inner diameter: φ12±1 |
Thermal Printing Surface | Wound on outside of paper roll |
Termination process | Do not glue the paper roll and axial wrapper. |