To add more SmartCams or re-install your current SmartCam to the Hedge app, follow the steps below.
If you get a new Wi-Fi network, you will need to re-install your SmartCam:
Tap on the SmartCam image from the Dashboard.
Tap the gear icon in the upper right corner of the live view image.
Scroll all the way down and find the Remove Device button, press it. Your SmartCam has been successfully removed from the Hedge app.
To re-install, follow the original setup instructions, listed below.
Note: The SmartCam will only connect to a 2.4GHz network; it will not connect to a 5GHz. If your router supports both, make sure you are connecting to the right one.
What do the LED colors on the back of the SmartCam mean?
Open the Hedge app and click the + button on the top right of the screen.
2. Click on the SmartCam in the device list.
3. Then click Get started.
4. Plug the SmartCam in and wait until the LED light on the back starts flashing yellow. This may take 10 seconds.
5. Click Next, then enter your Wi-Fi details. The best way to do this is to first connect your phone to the Wi-Fi network you would want the SmartCam to connect to.
NOTE: The SmartCam will not work on 5Ghz so make sure you connect it to a 2.4Ghz network, and note that the password is case sensitive.
6. Click the setup button under the SmartCam until you hear it say "Ready to Connect", then click the "I heard the voice say Ready to Connect" button in the Hedge app.
7. Show the SmartCam the QR code. If the SmartCam identifies the QR code, it will say "QR code scanned". If it doesn't say that, then make sure your the phone brightness is up to 100% also make sure the phone is level with the SmartCam.
NOTE: Once the QR code is created, it is only valid for 5 minutes.
8. Once you hear "QR code scanned" and click the button, the Hedge app will try to connect to your Wi-Fi.
8. When it connects to your Wi-Fi it will give you a Connection Successful message. This is where you can name the SmartCam also add a room where the SmartCam is located.
9. Select the Room location were you have put your smart cam NOTE: you can not click save until you have chosen a room name. once you have done that then you are all set 😄
10. Click Finish once you are done the app will close and restart and the camera will show on the home screen
If you have trouble please contact the technical support team.