• IMPORTANT: Tags should be tested before entering the units to ensure they are working.  This article includes instruction on how to test using an Actall test station. 

  • On the touchscreen you will see the keypad to enter the tags ID.  (an ID is found on each device, and is similar to the image below)

  • On the touchscreen computer enter the ID of the tag  into the "device ID to test" box

  • Then click "Start Test"

  • When you see this screen, push the button on the tag to test the tag

NOTE: Only push the button once, do not hold down as tag will not test until released.

  • Battery and alarm functions will be tested without causing an alarm on the system

  • The green testing line will start moving across showing listening for the test

  • If tag tests good for battery and alarming, you will see this screen “Test Successful” which means you are
    finished testing

  • If the system does not receive information from the tag “Try Again” will appear.

  • If tag tests good for good for alarm monitoring but has a bad battery, you will see this screen 

  • To ensure the successful operation of the device a new battery should be installed before using the tag.

Did this answer your question?