Skip to main content

How to configure estimated spend in Adnova Discover

Set the Frequency and CPM assumptions Adnova uses to estimate how much every brand is spending on an ad.

Written by Team adnova

The $ figure on an ad card — $78.8, $7K — is Adnova's estimate of what the advertiser spent on that ad. No platform publishes real competitor spend, so Adnova derives it from the reach it can observe, using two assumptions that you control.

Spend Configuration is where you set those two assumptions. Get them right and every spend figure in Discover becomes meaningful for your market; leave them wrong and every figure is off by the same multiple.

Where to find it: Hover over the left-side menu to expand it, then click Inspiration → Discover. Spend Configuration is at the top right.

Set your values

  1. Open Discover.

  2. Click Spend Configuration at the top right.

  • Frequency — The average number of times the same person sees an ad. Higher frequency means the same reach represents more impressions, and so more spend. — 2.5

  • CPM — What it costs to buy 1,000 impressions, in your currency. — $15

  1. Click Save.

Every estimated spend figure recalculates immediately — on the ad cards, in the ad details, and in the Spend filter.

Choosing the right numbers

Use your own account's real numbers, from the market and audience you actually buy in.

CPM is the one that matters most — it scales every estimate directly. If your Meta CPMs run at $30 and you leave the default at $15, Adnova will show roughly half the spend you should expect. Take a blended CPM from your own reporting for the same geography and season.

Frequency adjusts for how often the same person is reached. The default of 2.5 is a reasonable broad-targeting average. Raise it if you are modelling tight retargeting audiences, lower it towards 1 for wide prospecting.

💡 These are assumptions, not measurements. Estimated spend is best used to compare ads with each other — which creative is getting the most money behind it — rather than as a literal budget figure for a competitor.

How it affects the Spend filter

The Spend filter in the filter bar matches against these same estimates. If you filter for ads above $10,000 and get nothing, check your CPM before concluding that nobody is spending — a low CPM assumption pushes every estimate down.

Did this answer your question?