When the AMBR is connected to power, all LED lights turn on, then turn off, then turn back on one-by-one. Indicators can be diagnosed with this table.
The first light that should turn on is the green LED. It will begin by flashing to indicate that AMBR is starting up. After a few seconds, the light should turn solid indicating that it successfully started up. If the green light does not turn on at all, jump to the "If Behavior is not Normal" section of this article or contact support@amatiscontrols.com
LED | Flashing | Solid | Off |
Red |
| Power connection SUCCESS | Power connection ERROR |
Green | AMBR Starting up | AMBR Start up SUCCESSFUL | AMBR Start up ERROR |
Note: this table is only valid after AMBR has completed its startup sequence and the green LED is solid.
LED | Flashing | Solid | Off |
Orange |
| Offline data logging SUCCESS | Offline logging |
Blue | Data logging and configuration enabled SUCCESS | Data Logging enabled SUCCESS | Internet connection |
White | 6loWPAN SUCCESS |
| Normal operation |
Normal Behavior
red - solid
green - solid
orange - solid
white - blinking
If there are cloud connections:
Blue - on or blinking
If Behavior is not Normal
Scenario 1:
Blue - off
Check ethernet cables and check firewall settings.
Scenario 2:
Red - off
no power check power
Scenario 3:
red - solid
green - off
orange - off
white - off
blue - off
Power cycle, wait 2 min to get past Boot (blinking green), if no solid green, RMA