Pushing/pulling
To push pull:
Click the push/pull button in button bar. Alternatively you can use shortcut
PClick the face in the model that you would like to push/pull. Notice while hovering faces that they turn green if they are push/pull-able and red if they are not. You can click and drag to push/pull freeform → if you’d like to specify a particular distance, click without dragging and move on to step 3.
Move your mouse and click to complete the push/pull.
When performing a push/pull, a distance input is shown on the face of the push/pull preview. You can input a value → when the input has the value you want, press Enter or click to finish the push/pull.
You can hold Option/Alt while push/pulling to snap to other geometry in the model.
Push / pulling building faces
Push/pull has 3 modes - All, Floor, and None. You can switch between these modes by pressing the Tab key or by clicking on the mode button in the menu that appears in the bottom left when you're in the push/pull tool.
Push All: Pushing the entire face of the building
2. Push Floor: Pushing all floors with the same floorplan
3. Push None: Pushing just the selected area
