Peptide Measurement Guide
Peptide labels can look a little technical at first, but once you know what each measurement means, everything becomes simple. Here’s a quick, beginner-friendly breakdown:
mg (milligram)
The total amount of peptide in your vial — the “big number” on the label.
mcg (microgram)
How your actual injection dose is measured.
1 mg = 1,000 mcg.
ml (milliliter)
How much bacteriostatic water you add when reconstituting your peptide.
Unit
The markings on an insulin syringe used for dosing.
1 ml = 100 units on a standard insulin syringe.
Other Helpful Guides
Safe & Unsafe Places to Inject Peptides – Sites, Needles, Reconstitution, and Storage
Common Side Effects from Peptides
Who Should Avoid or Be Cautious With Peptides?
Optimal Storage for Peptides – Shipping, Lyophilized, and Reconstituted Guidelines
Disclaimer:
All peptide products sold on this website are for research, laboratory, and educational purposes only. They are not approved by the FDA or Health Canada, are not intended for human consumption, and should not be used for medical, cosmetic, or therapeutic purposes unless specifically prescribed by a licensed healthcare professional.
The information provided on this site is for informational and educational purposes only and does not constitute medical advice. Product descriptions, protocols, or references are not intended to diagnose, treat, cure, or prevent any disease. Always consult a qualified healthcare provider before beginning any new protocol, supplement, or treatment.
By purchasing from this website, you acknowledge and agree to use these products responsibly and in accordance with all applicable laws and guidelines.