We all know how frustrating it can be when the audio isn't working properly on your stream. Here are some common audio issues and how to troubleshoot them.

This is generally caused by either not enough gain or too much gain going to your BoxCaster or encoder. The most common culprits are gain structure, connection/device, and/or too many points of interception.

The BoxCaster Pro lets you adjust the analog input gain directly on the unit. The BoxCaster lets you make adjustments in +/-3dBFS increments from its Advanced Settings page. This solution is can help you adjust audio input levels that are too loud or too quiet, especially when you can’t physically adjust other equipment in your workflow.

We recommend you find an input level setting that works well for you and perform fine-tune adjustments on a per-broadcast basis using an audio mixer or video switcher.

The simplest method is to adjust the volume on the piece of equipment closest to your encoder. If you're running a switcher or coming off a split from a recorder, most of those devices have their own volume control. Adjusting these devices may solve the low volume. If you don't have a switcher and use audio directly from the console or source, adjust the volume in 1–2 dB increments until it’s better matched.

Audio is determined by channels, and there are typically only two channels any person will hear — left and right. If you're hearing audio in your streams coming through only one side, then you're streaming in mono. There are a few reasons why this happens:

The best way to solve this is to check your connections. Sometimes, audio being sent in stereo from the source is being converted to mono with your cable. Check to make sure your cable is able to handle stereo signals and that you're connecting it to the correct inputs on your encoder.

It’s also important to use the proper connector. If you're running audio from a console with one cable that’s marked for stereo, you should be aware that you're still running mono audio and your cable is converting the left or copying the left to the right side to make a faux stereo signal.

Viewers’ devices sometimes automatically take a mono signal and make it stereo. Advise them to check their device settings to disable that feature.

If you're hearing a buzzing noise or a hum, it might be that your audio is experiencing grounding issues. The best solution to remove the ground loop is to ground the source of your audio. If that’s not easily done, use a ground loop isolator. This will cycle your audio signal through a transformer and remove the loop.

Noise floor hum occurs when your gain or volume on the source is so high you can audibly hear the lowest frequencies. Noise floor sounds almost like ground loop, but it’s more like a hiss than a hum. To get rid of noise floor hum, try a hum eliminator or bring your gain down a little to keep from amplifying the floor noise in your stream.

This is a fairly common issue but don't worry, we've got some steps you can take.

We've got a few extra things you can try.

Ask that the viewer:

If this doesn't solve your issue, feel free to reach out to the BoxCast technical support team at questions@boxcast.com or through our chat.