summary: the WIP left sidebar has checkboxes for 31 available reports — click to add or remove them from your dashboard, or use select/unselect all to reset.

what's in play has 31 reports available to track — these are the reports with a live, real-time component that can surface active setups during a session. not every edgeful report works in WIP, so the selector shows only the ones that do.

the report selector lives in the left sidebar on the WIP page. it's a checkbox list — every report you tick shows up as cards in your WIP results. every report you untick disappears from the view. your selection directly controls what you're scanning for.

to add a report, find it in the left sidebar list and click its checkbox. it'll appear in WIP immediately.

to remove a report, click the checkbox again to deselect it. it drops out of the view without affecting anything else — your other reports, filters, and asset tabs stay exactly as they were.

there's no limit to how many reports you can have active at once, but a focused selection is easier to work with. most traders run 5–10 reports rather than all 31.

at the top of the report selector there are two shortcuts:

if you know which report you want, type its name directly into the search field in the report selector. the list filters as you type — so typing "gap" narrows it down to gap-related reports, and "IB" pulls up initial balance options.

this is faster than scrolling through the full list, especially when you have a specific report in mind.

when you first open what's in play, a starter set of reports is pre-selected for you. these are a solid starting point and give you immediate coverage of the most commonly used setups — you don't need to configure anything to get value from WIP on day one.

you can adjust this default selection at any time by checking or unchecking reports in the sidebar.

this is one of the most important things to know about the report selector: your current selection isn't saved between sessions. if you close WIP and come back, it may not remember exactly which reports you had active.

if you've built a selection you want to keep — say, 8 specific reports you run every morning — save it as a template. templates preserve your full WIP configuration so you can restore it in one click instead of rebuilding it each time.

see the templates article for how to create and use templates in WIP.

the what's in play report selector has 31 reports:

fair value gaps shows up as FVG - first presented. it tracks only the session's first fair value gap, counted the same way as the first presented filter on the fair value gaps report.

why isn't a report I use showing up in the selector? only reports with a live, real-time tracking component appear in WIP. if a report isn't in the list, it doesn't have a WIP-compatible version — it's available in the full reports section but can't surface live setups during a session.

I selected all my reports but my WIP looks empty — what happened? check your filters. the data filter, frequency filter, and bias filters can hide setups even when reports are active. if a report is selected but no setups meet your filter threshold, nothing will show for it. try widening the data filter, lowering the frequency filter, or clearing the bias filter to see if setups appear.

can I have different report selections for futures and stocks? not natively — the report selector applies to whatever asset tab you're on. the cleanest way to manage different setups is to save separate templates for your futures and stocks configurations and switch between them.