Skip to main content

Aerialytic Design: How to Fix Incorrect System Size

How to fix an incorrect system size on an Aerialytic design in Enerflo by resetting the panel layout using the Optimal Panels icon and saving the corrected design.

Written by Enerflo Support
Updated over a week ago

To access this guide as a PDF click here: Enerflo-Guide_Aerialytic-Design-How-to-Fix-Incorrect-System-Size.pdf

If the system size calculates incorrectly in your Aerialytic Design, follow these steps to fix the error. This can happen when panels are toggled on or off before the initial design fully loads or before the program can recalculate.

  1. Navigate to the Design stage in Enerflo.

  2. Click on the Design Card to open the Design.

  3. Click the Optimal Panels icon on the left side of the design image (it looks like a ground mount or solar panel). This will reset all panels and set the system size to zero.

  4. Click the Optimal Panels icon again to automatically fill the Design with the optimal panel placement.
    ​The system size should now be accurate. You can toggle individual panels on or off as needed.

  5. Click Save in the bottom right corner to apply the changes.

Attachment icon
Enerflo-Guide_Aerialytic-Design-How-to-Fix-Incorrect-System-Size.pdf
Did this answer your question?