Once you've installed your new Remote Pump Control (using the installation guide for Remote Switch or Remote Powerpoint), log into MyFarmbot and follow the below steps to configure your pump and automation settings.

1. Log into MyFarmbot

After logging in, you will land into the Map View. In the navigation menu on the left hand side, click into 'Pump Controls'

2. Choose your pump to set up

You'll see your newly installed pump(s) in the 'To Set up' section at the top of the screen. Click into the one you want to set up.

3. Updating the Pump Settings

Rename your pump and add an optional description. Click Next

4. Choosing a Destination Tank to display on the graph

Choose a water tank you’d like to display next to your pump controller and then set your pumps to automate of that tank.

6. Automation Mode

If you wish to have your monitor in Automation Mode, select 'Auto' button below the diagram and enter the 'Start' and 'Stop' level of your tank you wish to turn your pump on and off at.

If you would like your pump to only run during a certain period, please reach out to Customer Support on service@farmbot.com.au or 02 9901 4798 and the team can configure this for you.

You may want to set a Pump Operating Period:

The Pump Operating Period is a window of time the pump will automatically turn on, however, it is still based on the tank's level. I.e. the pump will not turn on during that time if the Destination Tank does not drop below the 'Start' level.