There are loads of variables to determine the best PA system. But you only need to know three tricks to get the best sound out of whichever PA speaker when using it with a wireless microphone!
High volume level
Volume adjustment will crank up or decrease both the signal and noise. So it is essential to set a proper gain in the very first place to avoid hissing or clipping sound and excessive noise. Keep in mind that both volume settings on both the wireless system and the PA system should be decent.
Turn off Bluetooth
Bluetooth is covered under the wireless “umbrella”. So, leaving the Bluetooth of your PA on, the wireless microphone is likely to run into problems, such as interference or even go further into malfunction.
Turn Bluetooth off when using the FIFINE wireless mic.
Choose the correct source input
There are all-in-one PA solutions for people who do not like to spend time setting everything up. But they would like to check if the correct input mode has been selected when a mic is plugged in. Otherwise, they will find themselves wasting more time on troubleshooting.
Switch to a suitable channel mode
The same 1/4” channel jack for both a microphone input and music on some of the PA speakers, which brings convenience as well as risk. If you do not have eyes wide open for the mic/line switch, you are going to get into a mess. When the jack is mis-switched to line in mode, it is going to have more impedance and thus less intensity of the mic signal you will get.
Switch from Line to Mic mode when using the FIFINE wireless mic. Otherwise, the output sound will be very low.
Notice: The wireless system of FIFINE K025 and K036 does not work with ECOXGEAR GDI-EXBLD810
