Skip to main content

How to Set Up Your Hellohacker Device

J
Written by Jonathan Bolduc
Unpacking and Physical Installation Remove the device from its box. The Hellohacker is designed to be installed directly in a standard server rack.For mounting, use the provided stud screws (quick-lock type screws). These screws allow you to easily slide and lock the device into the rack. Simply insert the Hellohacker into the rack rails and fasten it with the stud screws until it is firmly secured.

Once logged in, you'll see the main portal interface as shown above. Navigate to the Configuration section located in the bottom right corner to manually configure your network settings. This section allows you to adjust all necessary network parameters including IP address, subnet mask, gateway, and DNS servers. The interface provides two action buttons for managing your configuration: - Green button (Test) : Validates your network configuration without applying - Red button (Apply) : Saves and implements your network settings Important : When you apply a new IP address configuration, the device will automatically reboot to implement the changes. Your browser will be redirected to the new IP address, ensuring continued access to the portal if further configuration is needed.

Did this answer your question?