One of the ways to transfer Hive OS to SDD/HDD is to copy it from the flash-drive.
To do this, follow these steps:
Detect the drives (flash-drive and SDD/HDD). Use the command
fdisk -l
and check the results. For example:
Disk /dev/sda: 111.8 GiB, 120034123776 bytes, 234441648 sectors Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: dos Disk identifier: 0x244b7fbe Device Boot Start End Sectors Size Id Type /dev/sda1 2048 43007 40960 20M e W95 FAT16 (LBA) /dev/sda2 43008 188786687 188743680 90G 83 Linux /dev/sda3 188786688 234441647 45654960 21.8G 82 Linux swap / Solaris Disk /dev/sdb: 14.4 GiB, 15489564672 bytes, 30253056 sectors Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: dos Disk identifier: 0x244b7fbe Device Boot Start End Sectors Size Id Type /dev/sdb1 2048 43007 40960 20M e W95 FAT16 (LBA) /dev/sdb2 * 43008 14690303 14647296 7G 83 Linux
Disk /dev/sda: 111.8 GiB - judging by the size, it's SSD/HDD, and Disk /dev/sdb: 14.4 GiB is a flash-drive. Actually, in most cases /dev/sda is SSD/HDD, and /dev/sdb is a flash-drive.
Transfer the image of the flash-drive using the command
dd if=/dev/sdb of=/dev/sda bs=10M count=800 status=progress
if - this is the device from which we will transfer (our flash-drive)
of - this is a device where to transfer (SDD/HDD)
bs - this is a size of the block that is transferred at a time (10M is 10 Megabytes, "M" has to be capital, otherwise an error will occur!)
count - the number of blocks that have to be transferred, 800 will be enough (10800 = 8000Mb). You don't have to specify this, but in this case the entire flash-drive will be copied (in our example, that's 16Gb), despite the fact that under the file system there are only about 8GB. Besides, if the flash-drive has larger memory capacity than SSD/HDD, the process will end with an error. However, it will not affect the work.
After the process is over, you can boot Hive OS from SSD/HDD:
shutdown -r now
Don't forget to remove the flash-drive when rebooting, or simply change the boot device in BIOS.