Before using your Hydra Rinse system for the first time, we recommend performing a break-in procedure on the Pro-Control Module to purge it of any air trapped inside. To do this, you will be performing two self-clean cycles on the Pro-Control Module, this process will not take more than 2 minutes to complete.
Ensure 3 C-cell batteries have been installed, manifold assembly has been connected, and a water supply has been connected to the proper water source.
Ensure chemical cups are empty and on securely.
Connect water supply to the Pro-Control slowly.
Hold Pro-Control upside down and level over a bucket or sink to catch the water.
Initiate a self-clean cycle by pressing and holding the “Play/Pause” and “One Touch” buttons simultaneously, the control will beep and self-clean will start.
Water will flow from the manifold for 10secs, pause for 5secs, then flow again for 10secs.This completes the self-clean cycle; the LED’s will turn off and the Pro-Control will go back to sleep.
While still holding upside down, disconnect the water supply.
Initiate a second self-clean cycle without the water connected, holding the Pro-Control upside down.
This completes the break-in procedure.Your Hydra Rinse system is now ready to use.
Note: If when connecting the water supply, you hear water running; simply press the “Reset” button and perform this break-in procedure again.