1. Introduction
Remark Summary is a table to record the content which should be showed in the output report and not based on the period of the Report Data Table.
See the last section below for available sections of the Geosens Report.
The Remark content is specified with a prefix, @, e.g. @ThisBecomesRemarks, in the Notes columns.
For example, if the data period of the Report is set as 2 years, all @content for Remark Summary should be showed in the output report.
Please be noticed that the Remark content will not be showed in the Report when it is outside the Data Period.
The Remark content can be specified in the Instrument INIT, Revision Property and Data Records, as well as Station-Group INIT, with a prefix, @.
When the Remark content is from the Note column of Instrument INIT, Revision Property and Station-Group INIT, the Remark content will be in the NOTES table in the report.
See the screenshot below (Click on the image to enlarge it)
When the Remark content is from the Note column of Data Records, the Remark content will be in the Remark Summary table in the report.
See the screenshots below
2. Remark Content from Instrument
The Remark content can be specified in the Instrument INIT, Revision Property and Data Records.
In the Instrument page
In the INIT-NEW page
In the REV Property page
In the Instrument DATA page
3. Remark Content from Station-Group
In the Grouping page
In the STAT-INIT page
In the Station-Group DATA page
Depending on types of Station-Groups, Station Data can be retrieved and plotted in either Rail Monitoring page or Relative Deformation page. The user can enter Remark content in the Note column there.
4. Sections of the Report
The Geosens Report contains the following sections for now.
Report Header sections
Chart section
Location Map section
Sketch section
Report Data Table section
Remark Summary section, including NOTES and Remark Summary table
Report Charts
Report Data Table
Remark Summary
