Configure DMP IP Address and Account
Plug HDMI cable into Display/TV & then into DMP
Plug Ethernet cable into DMP and then into network wall outlet (Requires DHCP)
Plug DMP into the power source
Turn on the Display/TV
Turn on the DMP & you should see a Cisco Welcome Screen for only 30 Seconds (if missed, restart DMP)
Take note of the DMP IP Address (write it down, take a picture, utilize your superior memory bank, etc.).
By default, the Cisco DMP is set to DHCP. Please make sure that your network has DHCP enabled for the initial setup on the DMPs. If your network does not support DHCP, you can plug the DMP into a standard router to get the initial IP Address.
Setup Cisco’s DMP Admin
Enter the DMP IP Address from Cisco Welcome Screen (ex. – http://171.71.227.181)
When you go to your DMP IP Address, you will be asked to enter Username and Password (Username = admin, Password =default)The DMP may ask you to create a new password to access the device. If your DMP prompts for this, enter a new password and write it down. It is easier to use this same password when setting up all DMPs on your network. Also, you will need this password later on in the setup process.Click on left navigation links, update settings below:Select NetworkSet Dynamic IP Addressing to Disabled (Only leave this option set to enabled if you have reserved the DHCP address for your device. If the DMP’s IP changes, its communication with CCHD with be severed.)Enter appropriate network configuration data in the field below. (skip this step is a DHCP IP has been reserved and the DHCP drop down is set to enabled).Click Apply at the bottom of the configuration page
To make changes permanent, click Save Configuration and Restart DMP at the bottom of the configuration page
DMP IP Addresses are unique to your player and cannot be used more than once.
Setup DMP Settings
Select Flash
Update Splash Screen Display Time to 10000
Set Max Screen Width and Height720p = 1366 pixels (width) x 768 pixels (height)1080p = 1920 pixels (width) x 1080 pixels (height)
Click Apply
Click Save Configuration and Restart DMP
Setup Internal Storage – Read and Write
Click on Internal Storage
Set to Read and Write
Click Apply
Click Save Configuration and Restart DMP
Enable FTP
Click on DMP Management
Set FTP to enabled
Set HTTP Proxy to disabled
Click Apply
Click Save Configuration and Restart DMP
Adding your device into CommandCenterHD
Login to CommandCenterHD
Hover over Dashboard on the top orange bar and select Devices in the dropdown
Click Add Digital Signage Player
Create Device Name (ex. – Location of DMP “Lobby, Conference”)
Select a Device Model (Located on bottom of DMP): 4310
Select FirmwareOptions: 5.4, 5.3, 5.2, 5.1, 5.0, 4.X
Set player status to active
Select a Zone
Enter your Device IP Address
Enter Zip Code of DMP Location
Select Time Zone of DMP Location
Select DMP Channel
Select Type to Live
Select your resolutionMost typical option is 1920×1080
Click Save
Network must be configured per network topology
Issues?
Open a Case with the Industry Weapon Support Team or give us a call at 877-607-0562.