Configuration of the Indabox function
Connect your PC to the same network as the Indabox, then start the Indabox Configurator application.
After waiting a few seconds, click on the Refresh button.
Note : If no line has appeared in the device list in the box, repeat the operation.
Once a line has appeared, it means that the computer has detected an Indabox.
To configure it, select the line and click on the Function setting button.
The following screen appears :
You must now complete the following fields:
The serial number: a 5-digit identifier indicated on the front of the Indabox
The MAC address: a 12-digit identifier indicated on the front of the Indabox
The function of the Indabox: choice between its INDUS, CLOUD or Box Lite use
Once the information has been entered, click "OK" to save the information.
Carry out this action on the two boxes :
Indus - connected to the industrial network
Cloud - connected to the internet
Setting a temporary IP address
The IP address must be in the same range as the configuration PC for you to be able to access the Indabox Web interface.
If necessary you can set a temporary IP address.
Click on "Advanced mode".
Then, "Assign temporary IP".
Enter an IP address within the same range as the configuration PC, then click on "Ok".
Editing a box label
You have the possibility to change the label of your box.
Right-click the desired line and select the "Edit label" function.
Enter the new label, then click "Ok".
A confirmation message appears. Your label has been changed.
