Installation steps
Loading the EcoTab with chlorine
Open the compartment provided and insert up to 3 chlorine tablets. Make sure they are not broken or too small, to ensure optimum diffusion.
Remove the sticker from the solar panel of the EcoTab
By peeling off the sticker, the solar panel will activate and start recharging.
Check solar exposure
EcoTab runs on solar energy. It is therefore important to place it in a well-exposed area, without prolonged shading. Exposure for several hours a day is necessary to ensure energy autonomy. Wait a few moments for the solar panel to catch the light.
Place EcoTab in the pool
Simply place the device in the pool, ideally in an area where it will be regularly exposed to sunlight during the day. It will float on the surface.
Link EcoTab to the ioStrip app
Download the ioStrip app, select EcoTab and follow the steps in the app. It will take a few minutes in total to link EcoTab to your phone and WiFi.
Connection (optional) to an iopool EcO probe
If you have an EcO probe, select the “regulation” diffusion mode and follow the instructions to connect the probe to the EcoTab. This enables automatic regulation of chlorine diffusion according to measured needs (ORP).
And you're done! You're ready to enjoy your EcoTab.
Further information
No electrical connections or technical settings are required.
The EcoTab must remain in the water at all times during use.
The EcoTab requires good exposure to sunlight in order to diffuse properly.
No specific maintenance is required, apart from refilling with pebbles.