CE marks are only required in countries that have taken the European Norms (EN) and have then gone ahead and adopted those laser safety regulations. This is typically European Union (EU) countries such as Germany. CE markings are not required here in the United States nor in countries in North America. All of our laser safety glasses meet ANSI and OSHA requirements, the standards that are applicable in North America. Please reach out if you have any questions.

What is ANSI?

ANSI standards are created from volunteers and varied viewpoints and interests to achieve consensus on laser safety issues. Numerous organizations for the laser safety standards were represented, including government agencies such as the Federal Aviation Administration (FAA), branches of the U.S. military, different laboratories, including Los Alamos National Laboratory, and representatives from different organizations like the American Dental Association. The Laser Institute of America (LIA) servers as the secretariat and publisher of the ANSI Z136 series on laser safety standards—of which Laser Safety Industries is a proud member.

What are European Norms?

European Norms (EN) are formed in a similar capacity with the material difference that where these norms are adopted, they become law. Furthermore, an independent verifier must issue certification that a protection level is met.

As a result of working with large international corporate clients that require the CE certification, we have obtained the CE mark certification for particular frames (our frame 10 fit-over) on the following filters(110/111, 125/126, 130/131, 145/146). The fit-over (frame 10) marketed in the (110, 125, 130, and 145) are the exact same as the fit-over with the SKUs (111, 126, 131, 146) marketed with the CE certification. The material used in the filter/lens of the eyewear for (100-xx-110; 100-xx-125; 100-xx-130; 100-xx-145 product offerings) are all the same in each frame (and not to repeat information but this also means the same material for the filter/lens in the corresponding CE marked product (100-10-111; 100-10-126; 100-10-131; 100-10-146). To be clear, only the the fit-over frame 10 in the SKUs mentioned above have obtained CE certification, marketed as (100-10-111, 100-10-126, 100-10-131, 100-10-146). The remainder of the frames in the SKUs mentioned above (100-xx-110; 100-xx-125; 100-xx-130; 100-xx-145) have not been certified with a CE mark.

For corporate clients who are in need of this particular certification for a given filter/frame combination, we are always happy to work with them if the need arises to begin the certification process.

For further information on w these standards/norms, see our blog ANSI vs. CE.

Reading CE Laser Safety Notation

Example: European Conformity (CE) KTP Laser Safety Glasses, (our 110/111) the specifications are as follows:

Specifications: D 190-532nm LB6 | | I, R 190-532 nm LB7

Let's break down how to read the specifications:

The testing and corresponding certification process for a CE mark is on both the frame as well as the lens. The EN(s) have taken a very conservative approach, requiring testing on each particular frame as well as the lens.

Our laser safety glasses (and other PPE) are for diffused viewing and incidental direct hits; utilizing laser safety eyewear or other PPE for direct viewing for long durations of time (more than 0.25s for visible lasers - the reflex of the blink of the eye) is not proper safety. Never look directly into a laser.

We illustrated the difference in CE marked specifications and the OD specifications that are common industry notation here in the United States and North America.

In the image above, the image on the left would have the specification of an LB6, as it would be the minimum specification of the frame and the lens Min (LB6, LB7). Our optical density markings that are not CE marked are only a statement about the lens, and the image on the right would be marked with an OD7.