Skip to main content
Driver - Invalid Dip Level

Follow these steps to enter a 'Dip Level' for your pickup

Elisabeth Sanford avatar
Written by Elisabeth Sanford
Updated over 3 weeks ago

When entering the dip measurement for your pickup begin by entering the whole number for your dip reading where it says 'Reading' and the fraction of your measurement where the zero is.

Note - The Dip level will either be /32 IN or /10 CM. You cannot change this as it is dictated by the tank chart.

Below is an example of a dip reading of 10.5 Inches.

If you are entering the dip as above and getting an 'Invalid Dip' error reading try the following

  • Reconfirm you have the correct Tank selected if the Producer has more than one tank

  • Double-check your measurement

Still have questions? Hit the chat button in the bottom right corner of your screen to send a message to Milk Moovement’s 24-hour support line!

Did this answer your question?