This is a guide that shows how to install Monta on your charge point. If you want to connect your charge point to your Monta account, please follow the steps in the end of the guide.

Please note that when you connect your charge point to Monta, we become the operator of the charge point. This means that you need to use Monta to control the charging process.

Overview

  1. Establish a connection between your PC and the charge point

  2. Power on your charge point

  3. Give a static IP to your PC in the same network as your charge point

  4. Open up internet browser to 192.168.0.10

  5. Log into the admin panel

  6. Change password

  7. Select "OCPP Settings"

  8. Select OCPP connection mode

  9. Insert system address and serial number

  10. Connecting the charge point to your Monta account

1. Establish a connection between your PC and the charge point

The first step is to establish the connection between your PC and the charge point you will be integrating. This can happen in one of two ways:

(1) Connect your PC and the charge point to the same ethernet switch.

OR (2) Connect your PC directly to your charge point.

2. Power on your charge point

3. Give a static IP to your PC in the same network as your charge point

The charge point and your device must be on the same local area network, which will give them local IP addresses 192.168.0.X.

The IP of your charge point is 192.168.0.10.

You need to set your PC's IP in a range between 192.168.0.1 and 192.168.0.254. You can put the value of the last number to be anything between 1 and 254, except for 10.

For example, 192.168.0.11 can be set as a static IP to your PC.

To access these settings please press Win+R and follow the flow as shown here.

4. Open up internet browser to 192.168.0.10

5. Log into the admin panel

Here are the needed credentials for logging into the admin panel:

Username: admin

Password: admin

6. Change password

After logging in for the first time, you will be redirected to this page, where it is mandatory that you change your password. You are also able to change your password at any time by clicking “Change Password” in the login page.

Important! The new password must contain at least 1 lowercase letter, 1 uppercase letter, 1 numeric character and minimum 6 characters.

7. Select "OCPP Settings"

In the main menu, select "OCPP Settings"

8. Select OCPP connection mode

  • Select "Enabled" from the drop down menu, underneath OCPP Connection.

  • Click on the button "Set to default", besides OCPP Configuration Parameters.

  • Stay on this page.

9. Insert system address and serial number

On the same page, insert the information as shown in the example:

  • Central System Address: wss://ocpp.monta.app

  • Charge point ID: [serial number of your charge point]

  • Click on "Save"

10. Connecting the charge point to your Monta account

Now you need to add and connect your charge point to your Monta account.

You can do this through either the Monta app or Monta Portal.

Here is a guide for the Monta app.

Here is guide for Monta Portal.

Did this answer your question?