Overview

Section A: Hardware setup

  1. Configuring the charging station

  2. Connect your computer to the charge point by an Ethernet cable

  3. Open your browser and enter the URL

  4. Click on "Supervision"

  5. Make sure your charging point has internet connection

Section B: Setting up in the Monta Portal

  1. Add Charge Point

  2. Add Charge Point Settings

  3. Add Charge Point Details

  4. Connect to Monta

  5. Select Brand

  6. Select Model

  7. Select Integration Method

  8. OCPP Integration

  9. Check Connection

  10. Verifying

  11. Perfecto! You are now connected to Monta!

Section A: Hardware setup

1. Configuring the charging station

Scan a QR code on your charge point, which will direct you here for a step-by-step guide for Schneider charging box integration. Click on "Documentation" and then "Product Documentation". Scroll down to an instruction sheet and click on: EVlink Smart Wallbox - EVB1A22P - Installation guide. In page 35 you will find all the steps for configuring your charging box.

2. Connect your computer to the charge point by an Ethernet cable

After you have connected your computer with the charge point, set the static IP address properties as follows:

3. Open your browser and enter the URL

Enter the URL http://192.168.0.102 and log on with the following credentials:

  • User name: admin

  • Password: ADMIN

4. Click on "Supervision"

Once you are there, paste Monta server address that you copied earlier to the "Supervision URL": ws://ocpp.monta.app/

Afterwards, insert the serial number of your charge box ("Charging station ID").

5. Make sure your charging point has internet connection

Reboot your charge point and wait 30 seconds and refresh your window.

Now you should be able to go back to the main menu and register the charge point on the Monta app.

Section B: Setting up on the Monta Portal

Before setting up in the Monta Portal create the team. Here you can find information about how to create the team on Monta Portal and where to add your charge point.

1. Add Charge Point

On Monta Portal click on "Add charge point" under Teams section.

2. Add Charge Point Settings

Select Schneider and the charge point model, put max charging power (this information can be find on the charge point box or should have been provided by the manufacturer in this case Schneider) and select supported connector type.

3. Add Charge Point Details

You can add an existing Charge point group or create one for that specific location. If you already have a Charge point group pointing to the location of the charge point it will be added automatically.

4. Connect to Monta

Important! If you choose "Not now" you can connect your charge point to Monta later. Click on Charge Point Name - Set Integration.

5. Select Brand

6. Select Model

7. Select Integration Method

8. OCPP Integration

Important!! At this point of installation you will need to have the charge point serial number. Add Charge Point identifier and click on "Done, what's next?"

9. Check Connection

10. Verifying

Here we verify your connection to Monta. Please wait until the loading bar reaches 100%.

11. Perfecto! You are now connected to Monta!

Congrats! 🤗 You have now successfully installed your charge point to Monta.

Did this answer your question?