In this guide you will learn how to configure your Entratek charge point, so you can connect it to Monta. Please note, that there are two different types of configurations, depending on which Entratek model you have.

If you have a Power Dot Pro 2, please follow section A.

If you have Wallbox Power Dot Fix or Power Arrow Dual, please follow section B.

Section A: Power Dot Pro 2

Section B: Wallbox Power Dot Fix & Power Arrow Dual

Download the DS Charge mobile app on your device: App Store / Play Store

After you have done that you can login to the app with your credentials, or register a new account.

Turn on the Bluetooth of your device. A Bluetooth connection is going to be established between the app and the charge point, so you will see the charge point in the app interface.

Click on the charge point.

Once here, click on the three dots (...) in the upper right corner of the screen. This will open the internet configuration interface of the charge point.

Begin by clicking on the desired configuration network option.

Then follow the prompts on the page to connect to the network. You need to keep the device connected to the available WiFi. The app will directly connect to the WiFi connected to your device.

Check the box on "Websocket" to configure it.

Once the Websocket menu opens, insert Monta's web address:

ocpp.monta.app:433/

Click on "Link to router".

Now you just need to wait for the configuration to complete.

Now you need to add and connect your charge point to your Monta account.

You can do this through either the Monta app or Monta Portal.

Here is a guide for the Monta app.

Here is guide for Monta Portal.

Turn on your charge point and connect your device (computer, phone, etc.) to your charge point's hotspot.

Hotspot name: IOC-XXXXXX

Hotspot password: IOC12345

On the connected device, open a browser and type: 192.168.10.1:8080

Use these credentials to log into the page:

Username: installioc

Password: installer123

Click "OK" to proceed.

Navigate to tab "User" on top of the screen. From the menu, select "Basic".

Here, you need to change the URL address to Monta's URL. There, fill in the following:

OCPP Server Domain: ocpp.monta.app

OCPP Server Port: 433

OCPP Server URL: /

OCPP Identity: Insert the serial number of the charge point

Navigate to "User" on the top of the screen. From the menu, select "Network".

Enable internet access by making sure that "Block LAN visit Internet" is on "Allowed".

There are three ways to connect your charge point to the internet: Wi-Fi, Ethernet, 4G

If this is the first time you are connecting the charge point to the internet, you have to manually enter the Wi-Fi SSID.

If the charge point has been connected to the internet before, click on "Scan" and select your Wi-Fi network.

After you select the network, fill in your Wi-Fi password.

Please note that AP name and password can be changed, but you need to remember them, as it is currently not possible to retrieve a forgotten password.

The Ethernet connection is available with both DHCP and static IP. From the screenshot above, please see the DHCP option. This can be either enabled or disabled.

If you select "Enabled", the addresses will be assigned automatically.

If you select "Disabled", you can manually enter the charge point hotspot's static IP address and other information.

To connect via 4G, APN and Dial number must be given. Please check with the cell phone provider for cell phone connection information.

After all changes are submitted, reboot the charge point.

Now you need to add and connect your charge point to your Monta account.

You can do this through either the Monta app or Monta Portal.

Here is a guide for the Monta app.

Here is guide for Monta Portal.