Overview

  1. Connect your computer to your charge point

  2. Open a browser to 192.168.123.123

  3. Connect your charge point to the internet

  4. Configure the OCPP settings

  5. Reboot the charge point

  6. Connecting the charge point to your Monta account

1. Connect your computer to your charge point

Connect your computer to the charge point's controller via MicroUSB cable to the Config port.

2. Open a browser to 192.168.123.123

Open a browser your computer and type the following address: 192.168.123.123

Login with the provided credentials in Commissioning data sheet document that comes with the charge point.

3. Connect your charge point to the internet

In this guide, we are using an Ethernet connection as an example.

On the left side menu, navigate to "Network" and configure the LAN tab settings.

Show LAN Configuration: Show

Mode for ethernet configuration: DHCP server

Save the settings and move on to "Backend" section.

4. Configure the OCPP settings

Navigate to the "Backend" section on the left side menu and go to the "OCPP" settings.

Connection type: Ethernet

ChargePointID: Do not edit the ChargePointID

OCPP Mode: OCPP-J 1.6

WebSockets JSON OCPP URL of the Backend: wss://ocpp.monta.app

Save the settings.

5. Reboot the charge point

Reboot the charge point, so the new configuration can take place.

6. Connecting the charge point to your Monta account

Now you need to add and connect your charge point to your Monta account.

You can do this through either the Monta app or Monta Portal.

Here is a guide for the Monta app.

Here is guide for Monta Portal.

Did this answer your question?