This is a guide that shows how to install Monta on your charge point. If you want to connect your charge point to your Monta account, please follow the steps in the end of the guide.

Please note that when you connect your charge point to Monta, we become the operator of the charge point. This means that you need to use Monta to control the charging process.

Important - to establish OCPP connection to Monta backend, charge point firmware version must be 1.1.16 or higher.

Overview

  1. Download the eConfig app and connect

  2. Enter the PUK number

  3. Enter the technical settings

  4. Select backend and network

  5. Continue with backend settings

  6. Connecting the charge point to your Monta account

1. Download the eConfig app and connect

Download the eConfig app on your phone using Apple store or Google Play.

When launching the app, a guide appears, providing instructions to establish a Bluetooth connection to the eBox. Please, follow the instructions and establish a bluetooth connection with the charge point.

2. Enter the PUK number

After the connection is established, you will have to enter the PUK number.

The PUK is located on the back of the user manual that came with the eBox.

After this, you can select between Business and Private installation.

3. Enter the technical settings

Please note! It is very important that these values are correctly entered by a qualified person.

After you have entered the values, click on "Proceed".

4. Select backend and network

On this page, select "3rd Party Backend".

Proceed with choosing the network type you are going to use.

You can choose between WiFi (WLAN), LAN, and SIM connection. Enter the required information in one of the following and continue.

5. Continue with backend settings

When a valid internet connection is established, it’s possible to continue with backend settings.

Click on "Configure backend" and edit these settings:

Backend URL: wss://ocpp.monta.app

Chargebox Identity: make sure it’s the serial number of the charge point

The rest should be left as they were by default.

Press “Proceed” and now the charge point will establish a connection to the backend.

6. Connecting the charge point to your Monta account

Now you need to add and connect your charge point to your Monta account.

You can do this through either the Monta app or Monta Portal.

Here is a guide for the Monta app.

Here is guide for Monta Portal.

Did this answer your question?