This is a guide that shows how to install Monta on your charge point. If you want to connect your charge point to your Monta account, please follow the steps in the end of the guide.

Please note that when you connect your charge point to Monta, we become the operator of the charge point. This means that you need to use Monta to control the charging process.

Overview

  1. Notes

  2. Connect your phone to the charge point

  3. Open the Go-E app

  4. Connect the charge point to your local WiFi

  5. Configure the OCPP settings

  6. Reboot the charge point

  7. Connecting the charge point to your Monta account

1. Notes

For installing Monta on your charge point, you will need the following things:

go-eCharger reset card

This card should be supplied with the charge point. You will need it to read the QR code, as well as the charge point details.

The Go-E mobile app

You will also need to install the mobile app on your device: Google Play / App store

Please read the guide until the end and take note of the last step, as it is important for the connecting with Monta process.

2. Connect your device to your charge point

Begin the process by connecting your phone to the charge point. Please note that some devices require you to switch off mobile data and disconnect from any WiFi networks for this to work.

There are two ways to connect to the charge point:

a. Scan QR code - Scan the QR code that is on the reset card.

b. Search for the charge point's hotspot manually - In the settings of the device, search for the hotspot that the charge point is emitting. The details are on the reset card.

Hotspot name is "Hotspot SSID" (go-e-######)

Hotspot password is "Hotspot key" (##########)

3. Open the Go-E app

If you can see the charge point in the app, proceed to configure it.

If you do not see your charge point, add it in the app.

4. Connect the charge point to your local WiFi

In the bottom of the screen, select the "Internet" tab.

Then, select the "WiFi" bar and connect the charge point to your local WiFi.

5. Configure the OCPP settings

Open the "Internet" tab and go to "OCPP".

Enable OCPP 1.6 with the toggle.

Change the OCPP Server URL to wss://ocpp.monta.app/goe######

The numbers (#) are the same as the ones in Hotspot SSID.

6. Reboot the charge point

Click on the "Internet" tab again and click on "Reboot".

7. Connecting the charge point to your Monta account

Now you need to add and connect your charge point to your Monta account.

You can do this through either the Monta app or Monta Portal.

Here is a guide for the Monta app.

Here is guide for Monta Portal.

Did this answer your question?