The below image is a step-by-step guide to building our Till Stands. In the parcel sent you should receive all of the necessary tools to assemble these Till Stands, however, the stand should not need much assembly.
If for any reason, there are parts missing or you are unsure about any of the below setup processes, don't hesitate to get in touch with support@mypebble.co.uk
Flexibility in mind
350-degree rotation to face you or your customer
40-degree tilt offers more viewing angles
Under lock and key
Lock the tablet inside the frame using the hex key
Secure the stand on any countertop surface using the drill template
Remove the top left bumper pad, and then move the three other pads to the correct position – see the illustration for more detail. If the adhesive is not sufficient, use one of the extras found on the stand’s left-hand side.
With the stand in its upright position, insert your tablet's power cable into the stand’s opening. Flip the stand over or on its side and pull out the cable from the bottom.
Plug the power cable into your tablet and mount the tablet in the stand. For a good fit, make sure the cable follows the printed guide.
Replace the frame, starting at the top and guiding it down into place (use the aligning print on the back of the frame for guidance).
How do I secure my tablet inside the stand?
If you want to lock your tablet in the stand, use the hex key located in the stand’s base. At the bottom right side of the frame, insert the hex key and turn it clockwise to lock. Turn the key anti-clockwise to unlock.
How do I mount the stand to a countertop?
Use the provided drill template and two (2) M4 screws with sufficient length for your counter and the stand.
Place the drill template on the surface where you want the stand to be positioned. Use a 5 mm drill and drill two holes through the surface.
Place the stand over the drilled holes, lining it up with its screw inserts. Insert the screws from below and tighten.
Can I hide the tablet cable?
Yes, you can drill an additional hole in your counter at the middle of the stand and wire the cable through. By doing this you can tuck the cable out of sight and maintain a tidier space. Just make sure you use a sufficient drill size to fit and avoid damaging the cable.
Can I power the tablet on/off using the stand?
Yes, if you have mounted your tablet correctly (with its power button in the top left corner), you can use the button on the frame to power your tablet on and off.
Need POS new user training or refresher? - watch the video
If you have found this instruction manual useful please do give us a like below by selecting the smiley face 😊