Troubleshooting
By Assaf1 author32 articles
- How to make the Calibration accurate?Is there vaccine left in the bottle? What should I look for?
- Hand Unit leakage from the ports
- Hand unit- Orange light is stuckThe orange hand Unit light is stuck
- Empty blue screen on the Control Unit
- High viscosity vaccine
- Hand Unit- Injection without lights onSolving issue- injecting without lights on
- Hand Unit Flashlight is not turning onSolving issues- Hand Unit Flashlight is not turning on
- When will the injector not go back to the home position?
- How to check the actuator is at home position?
- How to insert the O-Ring back into the Injector?
- How to reassemble the Injection Head?
- Needle drippingWhat is the cause and what should be done?
- Injector bursting out
- No injection using an Automatic Injection HeadWhy is no vaccine coming out?
- Improper injection profileWhat should I do?
- C&D liquids spilling out from the cradleCleaning & Disinfection (C&D)
- Solving Injector IssuesHow to check and clean the Injector?
- The system gets stuck on the initialization screenSystem upload
- Injector chamber filled with vaccine
- The system can not be turned onHardware - batteries
- The injection head cannot be properly connected to the hand unit
- No vaccine flow through the needleThe vaccine doesn't come out from the needle
- The injector cannot be inserted properly into the control unit
- Can’t remove the Injector from the Control Unit
- Routine injection process is not starting
- The priming process is not filling the tubes with the injected materialSolving Priming Issues
- Dual mode fails to inject both materials
- The priming process has not startedSolving Priming Issues
- Secondary Control Unit not identifiedPrimary Control Unit does not detect the Secondary Control Unit
- The Control Unit is not powering on
- The display on the Control Unit does not turn onNo display and no light on the Control Unit
- The device is shutting down after performing an injectionSolving issue- battery