Adjusting Your Home Temperature via the SmartRent App Device
The SmartRent App gives you the ability to remotely adjust your home’s temperature and fan settings.
Changing Your Thermostat’s Mode:
To change your Thermostat's Mode:
Tap your Thermostat on the Home screen under My Devices
Tap the Mode bar
To turn the thermostat off completely, tap Off
To turn on your air conditioning, tap Cool
To turn on your heater, tap Heat
To keep your home from getting too hot or too cold, tap Auto
Changing the Fan Mode:
Your HVAC system’s fan is a motor that circulates air around your home. When set to Auto, the fan only circulates when the HVAC is cooling or heating the air. But when set to On, the fan will continuously circulate air throughout your home, even if the air isn’t getting cooled or heated.
To change your fan settings:
Tap your Thermostat on the Home screen under My Devices
In the Fan bar
To keep the fan on, tap On
To automate the fan, tap Auto
Adjusting Your Home’s Temperature:
To adjust the temperature using your SmartRent App, follow these steps:
Tap on your Thermostat on the Home screen under My Devices
Use your finger to tap the up or down arrow to adjust the temperature
Adjusting Your Home Temperature from the Physical Device
To change your mode:
Press the Mode button to change between Auto, Heat, Cool and Off
This will cycle between the modes upon each button press
To Operate the Fan:
Pressing the Fan button will change the Fan operation from Auto to On
When using On as the fan function, it will continue to run until you change it back to Auto
When using Auto as the fan function, it will operate only during the events that the HVAC system turns on for heating or cooling
To Adjust Your Homes Temperature:
When in heat or cool mode, you can press the Up or Down arrow to adjust the desired temperature
The temperature set-point will blink for 3 seconds and lock it in or you can press the fan button to confirm the set-point once set.