Create an accurate roof measurement report using aerial, satellite, or blueprint imagery.
Our DIY Reports tool is fast, easy to use, and allows you to measure roofs on your own time. Choose from our aerial images or upload your own to create quick measurements at a fraction of the cost of any other tool on the market.
How to create a Roofr DIY report
1) Select the structure
In the measurements tab in your Roofr Dashboard click Create DIY
Input the job address and click continue
On the image selection screen you will see multiple image options to choose from. Select the image where you have the clearest view of the structure you wish to draw.
Adjust the map center by clicking the pencil icon in the left corner and dragging the pin to ensure the roof is centered below the red tag.
Zoom in and out to include the entirety of the structures you are drawing by using the plus and minus icons.
Everything inside the picture window will be included in the image you use for your Roofr DIY report
Once you are happy with what is shown, click Select image
2) Square the structure
š”The first step to getting a clear drawing is ensuring the roof is as square as possible on your drawing screen.
Click the grid icon in the toolbox at the bottom of the Roofr viewer. This will provide a 90 degree grid overlay to square off your roof for drawing
Use the rotate icons on the bottom toolbar to square off the roof as best as possible against the grid
Click the grid icon again to remove the grid overlay
3) Draw the structure
Click the Draw tab at the top of the view screen
We recommend drawing the outer edges of the structure first
Your edge lines will turn white when they are at 90 degrees and yellow when on an angle
Lines will turn blue when they are fixed into the drawing.
Once you have the structure outlined, continue to draw lines over all edges of the structure.
Be sure to create your edges as close as possible to the features of the roof.
4) Label the edges
Select the Edge tab at the top of the view screen.
You will see a toolbox on the right-hand side of the screen with a list of roof edge types, such as eaves, valleys and rakes
Start labeling from the top of the structure to the bottom, and the top of the roof types first and then move down the list
To label the lines, click the edge type in the toolbar and then click the line you wish to label as that roof type
Switch labels by clicking another type in the toolbar and click to label those line types
š” Be sure to correctly label each edge. The edge colour will change depending on the edge type selected
5) Add pitch
Select the Facets tab at the top of the view screen
Note the layers window on the left and the pitch values on the right
Be sure to select the layer you wish to work on, or select āallā to access any facet on the roof
To add pitch to an individual facet, click on the pitch value, and then click inside the facet
Remember to switch between active layers when adding pitch to individual facets
š” If the whole layer is one pitch, you can select the bounding Box with the four arrows beside the pitch value to apply that pitch to the entire layer selected
5) Save and download
Your measurement will be listed as In progress until you mark it as done
The drawing will auto-save every few seconds, but you can click the save button to manually save at any time
Click Mark as Done to finalize your report
Download a PDF or CSV of the report by clicking the arrow icon on the top right of the view screen
How to DELETE AN EDGE:
Click the Edges button on the top navigation
Click the Delete Edge button on the right side navigation
Select and click on the edge you would like to delete
How to DELETE A FACET:
Select the Facet button on the top navigation
Click the Delete Facet button on the right side navigation
Select and click the facet that you would like to delete
How to DELETE A PITCH:
Select the Facet button on the top navigation
Click the Delete Pitch button on the right side navigation
Select and click the pitch/facet that you would like to delete