Setup Instructions

Scan the barcode in the order you see on this page, from top to bottom.

If you'd like to access the original manufacturer manual, click here.

Factory Reset

If you're starting with a brand new scanner, you can scan this barcode to be safe.

If something goes wrong in your setup process, scan this reset barcode to start over.

Disable QR Codes & Idle Time Setting (Recommended)

We recommend disabling QR code scanning to avoid accidentally scanning QR codes that are near product barcodes.

Set the idle time to 30 minutes

Prefix Setup (Required)

Scan each barcode in this section once and in the exact order shown. Do not skip or repeat any steps.

If something doesn't work, go to the top to factory reset the scanner. Then, redo the process from the top.

Remove First Digit (Optional)

This section is optional.

This section removes the first digit of a barcode as show in the example below.

Click here to see the example

Scanning this barcode is not part of the setup process. This is only an example of a barcode.

If you scan the sequence in this section, your scanner will not pick up the first digit boxed in green.

The sequence to remove the first digit starts here. Scan the barcode one by one.

Remove Last Digit (Optional)

This section is optional.

This section removes the last digit of a barcode as show in the example below.

Click here to see the example

Scanning this barcode is not part of the setup process. This is only an example of a barcode.

If you scan the sequence in this section, your scanner will not pick up the last digit boxed in green.

The sequence to remove the last digit starts here. Scan the barcode one by one.

Scanning Modes

Trigger mode

Auto-sense mode

Bluetooth or Wireless Mode

Bluetooth

Wireless

Advanced Options

Below are setup barcodes for more advanced customizations of your scanner.

UPC-A

Enable/Disable Ability to Scan UPC-A Barcodes

Transmit First Character (AKA Preamble)

Preamble characters (country code and system characters) can be transmitted as part of the UPC-A symbology. Select one of the following options to set and transmit a UPC-A preamble to the host: Transmit system characters only, Transmit system characters and country code (“0” for the United States), or Transmit no preamble.

Remove Preamble UPC-A

Include preamble, but not country code UPC-A

Include preamble for both system character and country code UPC-A

Transmit Check Digit

Check digit is the last character on product barcodes.

Disable check digit UPC-A

Enable check digit UPC-A

UPC-E

Enable/Disable Ability to Scan UPC-E Barcodes

Transmit First Character (AKA Preamble)

Preamble characters (country code and system characters) can be transmitted as part of the UPC-E symbology. Select one of the following options to set and transmit a UPC-E preamble to the host: Transmit system characters only, Transmit system characters and country code (“0” for the United States), or Transmit no preamble.

Remove Preamble UPC-E