Setup Instructions
Scan the barcode in the order you see on this page, from top to bottom.
Factory Reset
If you're starting with a brand new scanner, you can scan this barcode to be safe.
If something goes wrong in your setup process, scan this reset barcode to start over.
500 MS Speed & Disable QR Codes (Recommended)
We recommend disabling QR code scanning to avoid accidentally scanning QR codes that are near product barcodes.
Prefix Setup (Required)
Scan each barcode in this section once and in the exact order shown. Do not skip or repeat any steps.
If something doesn't work, go to the top to factory reset the scanner. Then, redo the process from the top.
Remove or Add First Digit (Optional)
This section is optional.
This section removes or adds the first digit of a barcode as show in the example below.
Click here to see the example
Click here to see the example
Scanning this barcode below is not part of the setup process. This is only an example of a barcode.
If you scan the sequence in this section, your scanner will not pick up the first digit boxed in green.
Remove First Character
Scan this barcode to remove the first character of the barcode.
Show First Character
Scan this barcode to show the first character of the barcode.
Remove or Add Last Digit (Optional)
This section is optional.
This section removes the last digit of a barcode as show in the example below.
Click here to see the example
Click here to see the example
Scanning this barcode is not part of the setup process. This is only an example of a barcode.
If you scan the sequence in this section, your scanner will not pick up the last digit boxed in green.
Remove Last Character
Scan this barcode to remove the last character of the barcode.
Show Last Character
Scan this barcode to show the last character of the barcode.
Convert UPC-E to UPC-A
This setting is to convert your short codes (UPC-E) to long codes (UPC-A)
Enable
Disable
