Scan the barcode in the order you see on this page, from top to bottom.

If you're starting with a brand new scanner, you can scan this barcode to be safe.

If something goes wrong in your setup process, scan this reset barcode to start over.

We recommend disabling QR code scanning to avoid accidentally scanning QR codes that are near product barcodes.

Set the idle time to 30 minutes

By default, your scanner uses the USB wireless mode, but this scanner can be connected via Bluetooth.

We recommend this mode if you the scanner for register checkout.

We recommend this mode when you need to connect to a tablet or smart phone for mobile tasks such as inventory counting or shelf restocking.

Scan each barcode in this section once and in the exact order shown. Do not skip or repeat any steps.

If something doesn't work, go to the top to factory reset the scanner. Then, redo the process from the top.

This section is optional.

This section lets you add or remove first digit of a barcode as show in the example below.

UPC-A (long barcodes) — Remove First Digit

UPC-E (Short Barcodes) — Remove First Digit

UPC-A (long barcodes) — Add First Digit

UPC-E (Short Barcodes) — Add First Digit

This section is optional.

This section lets you add or remove the last digit of a barcode as show in the example below.

UPC-A (long barcodes) — Remove Last Digit

UPC-E (short barcodes) — Remove Last Digit

UPC-A (long barcodes) — Add Last Digit

UPC-E (short barcodes) — Add Last Digit

Press button to scan

Automatically turns on when something is near the sensor

Always on