Make sure you have properly installed your Volt sensor before continuing with the web configuration.
On the module configuration tab, you can change how often the sensor bridge samples data from the sensor. When the Node collects data from the sensor, the sensor bridge reports the average value of the readings.
When the bridge is connected to a Node on battery, the sampling frequency is automatically set to 'Collect when data is polled' to optimize battery life.
The minimum (value at 0V) and maximum (value at 5V or 10V, depending on bridge model) conversion factors for each sensor can be configured under the conversion function under the same module configuration tab.
The data is directly available via data forwards or the Senseware dashboard. You can also remotely reset the sensor bridge in the module information section of the system status by clicking on the 'Reset' button and selecting either 'Soft Reset' or 'Hard Reset.' A soft reset will restart the sensor and a hard reset will erase the saved configuration.