Skip to main content

Selecting surfaces and edges

Select surfaces and edges in the 3D model one by one, or all at once per building, roof type or edge type.

Selecting a surface

With the Select tool (V), click a roof surface. The surface turns blue and its edges are selected with it. The model shows the area (m²) of the surface and the length of each edge. The colour of a length label shows the edge type.

Selecting several parts at once

Use Select at the top of the viewer to select, per building, in one go:

  • the whole Roof, or only Pitched, Flat (with Parapet), Chimney or Soffits

  • the Walls

Only the parts that exist in the building are listed. Use Select all or Deselect all next to a building's name to (de)select everything in that building.

Selecting edges by type

Click Edge types (E) in the toolbar. You see every edge type in the model. Tick a type to select all edges of that type, or untick it to deselect them again.

Viewing your selection

The Selection button at the top right shows how many parts you have selected. Click it to open your selection with all measurements. Read more in the article Viewing your selection and measurements.

Clearing the selection

Click Deselect all in the toolbar or press C.

Did this answer your question?