Skip to main content

How the configurator works

The configurator walks you through a module step by step and creates the work items, materials and quantities for you.

Starting the configurator

For a new quote, choose Use configurator. In an existing quote, click ⋮ next to Save quote and choose Add with configurator.

Choose a module:

  • Pitched Roof Configurator

  • Flat Roof Configurator

  • Facade Configurator

  • Solar Configurator — coming soon

The steps

On the left you see all the steps; a green tick shows which ones are done. On the right you answer the questions. Use Next step and Back to move forward or back.

Under Work Type, choose Renovation; Repair and Installation are coming soon. Under Site Preparation, tick for example Waste disposal, Scaffolding, Protective tarpaulins or Crane work.

Pitched roof

Work Type · Site Preparation · Existing Conditions · Demolition Work · Roof Structure · Insulation · Roof Covering · Dormers · Roof Windows · Roof Penetrations · Drainage

Flat roof

Work Type · Site Preparation · Existing Conditions · Demolition Work · Roof Structure · Insulation · Roof Covering · Roof Windows · Roof Penetrations · Drainage · Roof edges

Facade

Work Type · Facade cladding · Facade openings · Existing condition · Demolition work · Facade preparation · Insulation · Finish · Technical penetrations · Details & finishing profiles · Site requirements · Site setup and administration

When you are done

After the last step, Spotable creates the categories, cost items and resources, with quantities based on the measurements of your 3D model. Where possible, Spotable immediately links matching products from your distributor: the Smart Products. You then finish everything in the quote editor. See Editing a quote.

Tip: Are the suggested products wrong? Check that your distributor is connected under Settings → Distributors. You can also swap any product per line in the editor.

Did this answer your question?