Temperatures and Settings

Symbol	Smart Radiator Thermostat Basic	Meaning
		Target Temperature The target temperature for devices that have not been paired yet
		Manual Target Temperature Manual control is currently active at the displayed target temperature
		Manual Target Temperature below 19° Manual Control is active. Default target temperature of 17°, with further adjustment possible in the app.
		Home Target Temperature The Smart Schedule is active and in Home Mode at the displayed target temperature
		Away Target Temperature The Smart Schedule is active and in Away Mode at the displayed target temperature
		Open Window Detection An open window has been detected and heating in this room is currently turned off
		Child Lock Child Lock is on and Manual Control on the device is not currently possible.

Errors and Warnings

Symbol	Smart Radiator Thermostat Basic	Meaning
		Low Battery The batteries are running low and need to be replaced. When your batteries are depleted, manual changes on the device are blocked.
		Firmware Download The device is updating to a new firmware version
		Configuration Download The device is downloading its configuration
		Synchronizing There were changes to the device which have not been transmitted to other devices in the same room yet
		Pairing Error Pairing has not been successful
		Calibration End Position not Found The device did not detect the calibration end point
		No Contact during Calibration The device did not detect a valve during calibration
		The difference in Calibration Start and End Point too Small The difference between the detected start and endpoint of the calibration is too small

Symbol	Smart Radiator Thermostat Basic	Meaning
		Pairing The device is looking for an Internet Bridge
		Paired The device is successfully paired to an Internet Bridge
		Calibrating The device is looking for the start and end point of the valve it is mounted to
		Calibrated The device has calibrated successfully
		Unmounted The device is detected as mounted incorrectly. Unmount the device, restart it and mount it again to restart calibration.