Please note your camera may have a different interface and options may be located in a different part of the interface. Please refer to the camera manual if you are not able to find the relevant option.
Network
Set a Static IP
Set camera to unused IP on 192.168.88.x network
set DNS/Gateway to 192.168.88.100
Important: Although it's possible to configure your camera with DHCP, and TetherBox is capable of detecting any IP changes, we strongly advise against this practice for security reasons. This setting can potentially allow the camera to connect directly to the internet, raising a range of security issues. These include unauthorised access through back doors, or the risk of security holes in the camera's firmware if it's not updated regularly.
Video & Audio
Recording Stream (primary)
For 4K: H.264 4K 25FPS VBR - Quality: Medium - Type: Variable/VBR - Bitrate: 4096kbit - Key Internal: 50, No Watermark
For 1080P: H.264 1080P 25FPS VBR - Quality: Medium - Type: Variable/VBR - Bitrate: 2048kbit - Key Internal: 50, No Watermark
Analytics Stream (secondary)
Recommended: H.264 720P - 8FPS - Type: Variable/VBR - Quality: Medium - Bitrate: 1024kbit - Key Interval: 16 (double the frame rate).
The analytics stream is used to detect the objects vs background, please ensure this is 720P or below at 10FPS or lower.
Conditions
Anti Flicker: 50hz (in the UK, adjust for your desired locale)
BLC: WDR - Middle
Audio (optional)
Sampling Rate 16K
Enable Main/Sub Stream
Encode Mode: G.711A
Date & Time
One option is to disable time from being displayed in the camera at all. You generally do this under OSD settings. If you do wish time to be displayed in the image, you need to set the following:
Usually under Basic/System -> General -> Date & Time
NTP Server: Set to TetherBox IP address (usually 192.168.88.100)
DST: Set appropriate settings for your Timezone. e.g. British Summer Time begins at 01:00 GMT on the last Sunday of March and ends at 01:00 GMT (02:00 BST) on the last Sunday of October