Linear classifications are used to measure length-based takeoffs, such as walls, curbs, piping runs, or any scope where the primary quantity is linear footage.
To create a new linear classification, go to the Quantities Panel, click the "+" symbol on the right side menu and select "Create Linear Classification" .
To Create a New Linear Classification
Go to the Quantities Panel
Go to the Quantities Panel on the right side of the Drawing Editor.Add a new classification
Click the “+” button at the top of the Quantities Panel.Select “Create Linear Classification”
This opens the classification editor.Set classification properties
In the Create Linear Classification window, setup the classification details:Name: make it clear and specific, e.g., “Wall Paint”
Color: select from a wide array of colors for each classification
Output Quantities and Units: Length is the default quantity; and you can add additional outputs as needed), such as:
Vertical Area 1 Side (1 side of the vertical area of a wall)
Vertical Area 2 Sides (Vertical area of both sides of the line)
Vertical Area All Sides (Vertical area of both sides of the line and top & bottom)
Horizontal Area
Volume
Perimeter
Classification Dimensions (Optional): input height/thickness/offset/slop to calculate other quantities
Classification Folders (Optional): organize by trade, phase, or CSI division
5. Save the setup
After the setup, click Save. Your Linear classification is now ready to use.
Draw a Linear Takeoff
Activate the linear classification
Double click the classification name or single click the line icon in the Quantities Panel to activate the linear classification.Trace the path
Click to place points along the line you want to measure.Finish the line
Double-click to complete the takeoff. The quantity updates automatically in the Quantities Panel.
Edit an Existing Linear Classification
Use this when you need to change the name, appearance, outputs, units, or dimensions of the linear classification.
Locate the classification in the Quantities Panel
Right-click the classification and select “Edit”to open the Edit panel
Update properties such as:
Name
Color
Output quantities and units
Dimensions (e.g., height inputs used for calculations)
Save the changes
Classification Properties for Linear Classifications
You can specify Height, Thickness, and Slope in the classification properties:
Height/Thickness are used when you need area- or volume-related outputs (e.g., vertical area).
Slope impacts the length calculation only.