Users can now configure their Automatiq Feed Sources on a listing level
Previously, the Automatiq Feed would include all mapped underlying sources, with no way to adjust which are included in your criteria. Now, you can select the sources on a listing level if you'd like to exclude sources from your criteria.
a. When selecting the Automatiq feed, there will be exchange bubbles for each exchange with checkboxes next to them.
ii. If the checkbox is selected, that source will be included in the Automatiq feed. Unselecting the checkbox will remove it from the Automatiq feed.
iii. NOTE: Unmapped (grayed out) sources are available to select/deselect for inclusion in the Automatiq feed. This is because not all sources add events at the same time. If you leave the unmapped source included, it will be added to the Automatiq feed once the exchange is mapped and available.
iv. As the sources included are changed, the feed will be re-deduplicated to reflect only the present listings.
b. In the Automatiq Feed portion of the Uptick Settings, there is now an option to set your default source configuration. Once configured, all new criteria set on the Automatiq feed will default to only using the select sources from the settings.
i. Each listing's sources can still be altered by selecting the checkboxes on the Automatiq feed tab at any time.
2. Better visualization of duplicates in the Automatiq Feed
All duplicates will be nested with the listings they're duplicating, allowing for better visualization and price comparison across exchanges. Previously, any listings in the Automatiq feed that were marked as duplicates would show up in the comps, only sorted by price order.
Before
After
3. Enhanced Automatiq Feed settings
Users can now adjust the sources included in the market data and if duplicates are shown by default. Navigate to the Automatiq feed portion of the Uptick settings to adjust all of your Automatiq feed defaults!