This guide covers how to pair an Epson Mobilink Bluetooth printer (TM-P20II, TM-P80II, TM-P80II Plus) with your iPhone or Android device for use with the CleanCloud Driver App beta ↗️.
Step 1 – Enable Bluetooth on Your Phone
iPhone
Open the Settings app
Tap Bluetooth
Turn the toggle on
|
 |
Android
Open Settings
Go to Connections (this may vary depending on your phone model)
Tap Bluetooth
Turn the toggle on
|
 |
Step 2 – Put the Printer into Pairing Mode
The steps below apply to Epson printers. Steps may vary slightly depending on your printer model.
Open the paper roll cover
Press the Feed ⬆️ button until you hear a buzzer sound, then release it
Close the paper roll cover
A Next Action sheet will print
Press the Feed button once, then press and hold it again
A Bluetooth Interface sheet will print, showing the printer's device name (e.g. TM-P20II_XXXXX). Take note of this name as you will need it in the next step
The printer will enter Pairing Mode for one minute
The Bluetooth LED on the printer will start blinking to confirm it is in pairing mode
📌 Note: The Bluetooth status sheet will provide you the name of the device, which you will need to pair it with your phone.
Step 3 – Pair the Printer with Your Phone
iPhone
Go back to Settings → Bluetooth
Under Devices, find the printer name shown on your Bluetooth Interface printout
Tap the printer name
Confirm it shows as Connected
 |
|
Android
Go back to Settings → Connections → Bluetooth
Tap Pair new device
Select the printer name shown on your Bluetooth Interface printout
Tap Pair when prompted
|
 |
|
 |
Step 4 – Confirm the Connection
Once paired, the Bluetooth LED on the printer will change from blinking to solid, confirming the connection is active.
 |
 |
✅ You can now connect the printer to the CleanCloud Driver App and test it.
👉 For more on the Driver App beta, including supported printers and setup, see Getting Started with the CleanCloud Driver App Beta.
🛟 Need more help?
Explore our Help Center articles for answers. Contact us for further assistance.