Start with the log in screen. Enter your email and password in their respective fields, and press "Sign In."

If you have multi-factor authentication enabled, enter it on the next screen, and press "Authenticate."

For more information on MFA or to sign in with a recovery code, please see the MFA docs.

Once you authenticate, you will see your Enclaves load. Wait for the spinning wheels to disappear before clicking on an Enclave. You should see the following screen, with a list of your own Enclaves.

You are ready to select your network.

Tap on the Enclave to which you are connecting. In this example, we are connecting to Remote Access Demo.

You should see your Enclave name at the top of your screen.

You may get a message reminding you that you have not connected to the end destination yet.

To connect all the way through, please tap the name of your facility.

You should see your facility name at the top when you are fully connected.

Note

In the list of Enclaves, If you see a yellow dot next to the Enclave name, that means that you are connected to the Enclave but not to a destination location yet.

If you see a green dot, then you are fully connected.

Message us on the chat bubble on the bottom right of this page, or email us at hello@dispel.io. We always respond.