Below you'll see the process step by step for the TROLL series of sensors as well as tips for troubleshooting and understanding model specific features.
Setup Instructions:
Connect a 12V power supply to the 3 pole Euroblock connector or 5V power supply to either of the USB ports.
Plug the RS-232 splitter cable into the Thiamis RS-232 port and connect RS-232 TROLL Com adapter (PN 0056140) to Port A leg --OR-- Plug USB TROLL Com adapter (PN 0052500) into Thiamis USB Port.
Connect TROLL Com to TROLL cable --OR-- a Direct Connect TROLL Com directly to the sensor.
Note which sensor is connected to each letter port for configuring in Environet when Adding Sensors.
How to Connect
Errors
When the TROLL is not reporting, check the configuration page or hover over the red status indicator for more information.
Timeout
The TROLL has not responded to the requests made by the Thiamis and has timed out. It will continue to attempt communication but you can run through the general Troubleshooting Sensors steps to address common problems.
Tips on Specific Models:
None
List of Supported Models:
Click on names for links to manufacturer user manuals.
Aqua TROLL 100
Aqua TROLL 200
Baro TROLL (R)
Baro TROLL 500
Level TROLL 300
Level TROLL 400
Level TROLL 500
Level TROLL 700
RDO PRO
RDO PRO-X
RDO TITAN
Sensors Requiring Testing:
Aqua TROLL 400
Aqua TROLL 500
Aqua TROLL 500 (V)
Aqua TROLL 600
Aqua TROLL 600 (V)
Flow TROLL 500
smarTROLL
TROLL 200 (R)