If you are looking for where your HVAC module is located. It will be located in the center console and will look like this image below:
This is what is included in your Kit. The colors and arrows represent where the parts are supposed to go.
Please ensure that you have this extender:
Here are a few steps to follow once you have all of your parts:
| this 52 pin female connector ( the one with the green, yellow, white etc color wires) will plug into the extension cable that has the same color wires ( Please see below) The other end of that extension cable will connect to your previous sync module |
| Then the Pin with the clip on it will attach to the back of the APIM |
| There will also be a Sirius travel link antenna that you will not use so please disregard it |
| There is a small flat grey connector with a red and black wire will go into the back of your media HUB |
| There will be a RCA female plug for you back up cameraAnd last but not least there is a small black piece that has yellow and green wires that will clip to the back of your bezel for Hvac Now the harness you are about to receive has nothing to do with the repining that is required to maintain your HVAC controls.
|
And last but not least there is a small black piece that has yellow and green wires that will clip to the back of your bezel for Hvac controls (it does not say for travel link on the tab, If you do not have travel link please disregard).
Now remember the extended harness has nothing to do with the repining that is required to maintain your HVAC controls. Please see link below
Attention Installers - To retain climate functions you may have to perform a special install procedure. CLICK HERE for a quick video.