The software, previously referred to as "Toolbox", was rebranded to the name "Microvellum" in the year of 2025. If your software version was released prior to the year 2025, you may see certain settings with different names reflecting this change, such as 'Toolbox Setup' becoming 'Microvellum Setup'.
This document explains the steps required for the “Unexpected Stimulsoft references found” message.
Why do I see this message?
Microvellum resolved an issue that previously caused these files to become dislocated from the intended folder.
How do I resolve this message?
This message informs the user that Microvellum AC requires “elevated user privileges” or must “manually delete all Stimulsoft assemblies.” This notification is intentional and requires a one-time configuration, as instructed below. Failure to configure these files will cause reports to be unusable in Microvellum AC.
Elevate user privileges (Two options)
Close Microvellum AC, right-click the AutoCAD shortcut icon, and select “Run as administrator.”
If you see the message, “Unexpected Stimulsoft references found” again, continue to step two or manually delete all the Stimulsoft assemblies as instructed further below.
Higher Microvellum software permissions are required and granted by your user account administrator. For more information about Microsoft user account permissions, click here.
Manually delete Stimulsoft assemblies
Delete these files (as shown below) by following the file path provided in the notification. Deleting these files is necessary and may require elevated user account privileges (as mentioned in step two).