In the unlikely case of observing faulty repetition detection or missed repetitions during a set, you can edit the sets to correct these. The PUSH Pro Application will typically clean up these errors automatically when creating the post-set summaries, however, you still have the ability to input repetition number corrections manually.

For more information on how the PUSH Band sanitizes repetitions please click the help article link below:
​

Both the load and repetition values can be edited in the PUSH Pro application for any completed set. This is possible regardless if these values were pre-prescribed by a Coach through the PUSH Portal, or left blank.

Once a set has been completed select the 'Edit' icon next to the rep number.

From the edit screen, you can amend both repetitions performed and load lifted. You can use the '+' or '-' buttons to increase or decrease by one unit or click on the respective number fields.

Clicking a number field will display the input calculator for rapid number entry as well as the ability to convert between kilograms and pounds. Select "Confirm" once a change has been made.

To save your changes, click 'Save'.

Sets in an uncompleted or open session can also be adjusted by selecting the session from the Train screen.

Next, edit the desired set by swiping from the left to the right.

This will then provide the 'EDIT' display through which you can alter the set following the same process as outlined above.

NOTE: Sets can not be altered or edited within the PUSH Pro Application once a session has been completed.