Skip to main content

🪪 Renter Requirements: Minimum Age and Reusing Documents - v4

Set a minimum renter age warning and reuse a repeat renter's license, insurance and rental agreement for a set number of days (V4 only)

The Renter requirements section lets you set a minimum renter age and reuse a repeat renter's license, insurance and rental agreement. This is only available on V4. If you're on the original system, you'll need to upgrade to V4 to use it.

📍 Where to find it

  1. In the admin console, go to Rental Settings.

  2. Find Renter requirements. It's on the Rental Settings page, but you may have to scroll down a ways to see it.

  3. Make your changes and click Save changes. Changes apply to every booking the moment you save.

🎂 Minimum renter age

Leave it blank and no minimum age is set. This is how every account starts. A renter under 21 still gets a review note on the AI document check.

Enter an age and every license read from then on is measured against it. If a renter is under that age, the AI document check shows a STOP for your staff to see.

⚠️ It is a warning, not a block. Nobody is stopped from booking or signing, and rentals already taken are never re-checked.

💡 Pro Tip
Most insurers who set a minimum age set it at 25.

🔁 Reuse a repeat renter's documents for (days)

Leave it blank and every renter fills out the rental agreement and photographs their license and insurance every time.

Enter a number of days, such as 30, and someone who rented within that many days doesn't have to fill out the rental agreement or upload their license and insurance again. A repeat renter is matched on both name and phone number.

  • Documents must still be in date. Anything expiring within a month of the pick-up is asked for again anyway.

  • The rental shows where the check came from. It shows which earlier booking the license and insurance check was taken from.

  • No new photo is stored. You can always ask to see the card at the counter.

💡 Pro Tip
Want repeat customers to skip the rental agreement? This is the setting to use. There's no separate option to mark an agreement complete for a customer.

Did this answer your question?