1. Find your Camera, and ensure you have "Camera Analytics" enabled. You can find this by editing the camera and switching to the "Advanced" tab:
2. Tunnel into your Camera / Device:
3. Log into the camera using the admin account and press on “Configuration”
4. Press on “Events” & select “Basic Event” settings
5. Select “Motion Detection” and then:
Select “Enable Motion Detection” + “Enable Dynamic Analysis for Motion”
Select "Draw area" - Then use your mouse to select the area you would like to scan for events & motion.
Select "Stop Drawing"
Press "Save"
6. Select “Arming Scheduled” and then select use the blue sliders to adjust the time and days you would like the analytics to be enabled.
Press "Save"
7. Select “Exception” and then select.
“Notify Surveillance Center”
Press "Save"
8. Select “Smart Event” and then use the the categories to enable or disable the cameras Smart event detection.
Eg. "Sudden Increase of sound Intensity Detection" can be used if the camera is in a quite area and a loud noise can trigger an event.
Press "Save"
9. Finally logout of the camera and return to the TetherX events page.
You should start to see the events in TetherX with icons representing the analytics that were detected:
