If you are trying to setup your Aethair PRO hardware, please check out this article:
Access the Aethair PRO Configuration Page [click to expand]
Access the Aethair PRO Configuration Page [click to expand]
The Configuration page gives you full control over your Aethair PRO. You can access the Configuration Page in two different ways:
From the Devices List
Navigate to the Devices page, and find your Aethair PRO in the list.
Click the 3-dot menu on the right side of the device row.
Click the Edit button to configure your device.
From the Device Monitoring Page
Click Edit in the top-left, above your device's name
The Edit Page gives you full control over your Aethair PRO device. There are two main sections:
The left side of the page contains Device Configuration.
The right side contains information about the Gas & Additional Sensors.
Note on shared devices: You cannot configure devices shared with you, regardless of role. Configuration is only available for devices owned by your organization.
Device Configuration
1. Device Details
This section provides an overview of your device, including:
Online/Offline status
Model name and serial number
Battery/power source indicator
Owner organization
Network connectivity
Organizations the device is shared with
2. Device Settings
Here you can configure basic operational settings:
Device Name – Rename your device.
Device Description – Add a short description for identification.
Reporting Interval – Determines how often the device collects and reports data. Longer intervals reduce the amount of stored and transmitted data.
Connectivity (WiFi) – Configure WiFi network access:
Select your WiFi SSID from the dropdown list. If not visible, click the refresh button.
Enter your WiFi password and click Save to push credentials to the device.
Initial WiFi credentials must be delivered via cellular connection. After saving, wait a few minutes for the device to update and switch over.
If your device is deployed in an area without cellular coverage, you must preload WiFi credentials before deployment.
If no cellular network is available, click the ? icon to access Default WiFi settings and instructions for configuring a mobile hotspot or router.
Location – The device location is automatically configured via GPS and WiFi (Auto). If unavailable, switch to Manual mode to enter an address or coordinates.
3. Parameters
This section lists all parameters monitored by your Aethair PRO.
You can also create Statistical Parameters:
Click Create (or the + button in the Parameters List on the Device Monitor page).
Set the following settings:
Function – Average, Difference, Maximum, or Minimum
Parameter – Choose which parameter to base it on
Period – Time period for calculation
Name – Name your statistical parameter
Click Create in the bottom-right corner to save.
Your new statistical parameter will appear in the Parameters List and can be viewed in the Monitoring Page.
Gas & Additional Sensor Information
On the right side of the Configuration Page, you’ll find details about all additional sensors installed in your Aethair PRO. This includes Gas Cartridges, the MultiSense Module, and the Differential Pressure Sensor.
Aethair PRO has 3 locations for sensor sockets:
Gas Cartridge Sockets (2x) - Two front-facing sockets beneath the cover, used for standard gas cartridges. Installation Instructions
Expansion Socket - One front-facing socket beneath the cover, to the right of the gas cartridge sockets. Installation Instructions
Wall Socket - Rear-facing socket located on the back panel. This houses the power connector but may also include accessories such as the Differential Pressure Sensor. Installation Instructions
Each module in the right-hand column represents one installed sensor.
At the very top of each module, is the title bar which shows Device Status (Blue is online, Grey is offline) with the Cartridge Name and the Socket it is inserted into. The top section of each module shows an icon of the sensor along with the Model and Communication Port/Socket. When you install or replace a cartridge into one of the sockets, it will automatically show up in this space.